Barrie gets lake-effect snow off Georgian Bay that the GTA simply doesn't, and Kempenfelt Bay funnels wind straight into town. Roofs here work harder. Highland has been installing metal across Barrie for over twenty years, from the Ardagh Bluffs down to the water.
Barrie gets lake-effect snow the GTA simply does not, and Kempenfelt Bay funnels wind straight into the middle of town. Roofs here carry more load for longer, and a winter that is merely inconvenient further south is a genuine test up here.
The housing runs from older streets near Centennial Beach to the newer building out around Mapleview and the Ardagh Bluffs. The newer subdivisions are more exposed — higher, more open, less mature tree cover to break the wind.
01
Roofing homes in Barrie
The older streets near Centennial Beach are sheltered; the newer building out around Mapleview and the Ardagh Bluffs is higher and far more open.
Most of the decision is the profile rather than the colour. A deep tile like Banff suits older roofs with steep pitches and plenty of visible surface; Standing Seam is flatter and cleaner and sits better on a long modern run. Banff is available in black only; Standing Seam offers eight finishes.
Eight finishes
Black 9005 through Terra Cotta 8004, on every profile except Banff.
Snow
sheds rather than holds it, so there's less weight on the structure and less ice building at the eaves.
Summer heat
reflective coatings cut how much reaches the roof deck.
02
Commercial roofing
The Bayfield corridor holds most of the commercial roof area, on buildings that are wide, low and flat.
On a commercial building the case for metal is mostly about what stops happening. Flat and low-slope roofs need attention on a cycle, and that cycle costs money whether or not anything has actually gone wrong — inspections, recoating, patching, and scaffolding booked every few springs. Metal takes most of it off the calendar.
Fasteners
Standing Seam fixes with concealed fasteners, so there are no exposed screws to work loose.
Finish
matched to the existing brick, cladding or curtain wall rather than fighting it.
Long runs
panels are rolled in Europe and cut to the building, so there are fewer joints.
03
New builds and custom homes
Barrie is still expanding south and west, onto ground with very little mature tree cover to break the wind.
The useful time to involve a roofer is while it is still on paper. Pitch, valley detailing and how the panel meets the fascia are all cheaper to resolve at the drawing stage than on site. We would rather be in the conversation with your architect early than be handed a finished deck and asked to make it work.
Early involvement
we work with architects and builders through detailing, not just at installation.
Seven profiles
the roof can be part of the design rather than a constraint on it.
Lifespan
metal outlasts asphalt by a wide margin, which matters on a house you intend to keep.
04
Eavestroughs
Kempenfelt Bay funnels weather straight into town, and lake-effect snow arrives faster than most eavestrough can clear it.
Metal sheds water fast — that is the point of it — but it does mean more water reaches the eavestrough in less time than a shingle roof would send down. Undersized or leaking gutters are the usual reason water ends up sitting against a foundation, so we size the system to the roof rather than fitting it afterwards.
Coated steel
four protective layers, warranted 40 years by the system's manufacturer.
Sized to the roof
metal sheds water faster than shingle does, so the system is sized for the roof rather than matched to whatever was on the house before.
Coordinate the eavestrough finish with your chosen roof. Confirm the available materials and colours.
SEVEN PROFILES. UP TO EIGHT COLOURS.
Roofing in Barrie?
Free, no-obligation quote.